Reactor A-XP1

The Reactor A-XP1 is a Graco-engineered entry level coatings proportioner that gives you the reliability you expect on the jobsite. It maintains consistent temperature control, even when you're spraying at maximum flow rates – resulting in better quality coating.

For polyurea coatings – applies up to 5.7L per minute.

Three Heat Zones

  • Three independent heat zones – ISO, resin and hose heat
  • Provide accurate heat control for reliable spraying to handle different chemical viscosities
  • Digital temperature controls

NXT Air Motor

  • Low air consumption for increased efficiency
  • Muffler provides low operating noise levels

ISO Pump Lube System

  • Prevents isocyanate crystallisation on the pump seal and shaft
  • Easy to operate and maintain

Best choice for affordability and durability

  • Maintains temperature set-points for better yield
  • Maintains consistent output pressure for uniform spray pattern


  • Maximum flow rate: 5.7L/min
  • Maximum Working pressure: 138bar/2000psi
  • Maximum Hose Length: 210ft/70m
  • Maximum Fluid Temperature: 88
  • Air compressor: 45cfm @90psi, external compressor
  • Power Supply: 400V, 30A, 3-phase
  • Dry Weight: 113kgs